Post by The Guardsmen on Oct 10, 2010 13:58:15 GMT -5
You will need
Guardsmen Head
Green Stuff
exacto knife
small file
STEP 1
Select you head but leave part of the frame still attached to the head (so that is easier to handle.) Then mix up a SMALL amount of GS (refer to picture)
STEP 2
Push the GS into the general mask shape (see image.) But make sure you push it "under" where the helmet meets the face.
STEP 3
Push the area of the mask at the nose flat and give the area around the chin a slight upward angle.
STEP 4
Press the tip of you exacto knife into the GS to represent vents, using the knife press the area beneath the eyes downward and iv it a slightly rounded shape
STEP 5
Let Dry over night
STEP 6
Using the small file (or fine fine sand paper) neaten up you work.
STEP 7
Mix up a VERY SMALL amount of GS and using you knife press a little bit on to each side of the mask round it out and you are done!
Guardsmen Head
Green Stuff
exacto knife
small file
STEP 1
Select you head but leave part of the frame still attached to the head (so that is easier to handle.) Then mix up a SMALL amount of GS (refer to picture)
STEP 2
Push the GS into the general mask shape (see image.) But make sure you push it "under" where the helmet meets the face.
STEP 3
Push the area of the mask at the nose flat and give the area around the chin a slight upward angle.
STEP 4
Press the tip of you exacto knife into the GS to represent vents, using the knife press the area beneath the eyes downward and iv it a slightly rounded shape
STEP 5
Let Dry over night
STEP 6
Using the small file (or fine fine sand paper) neaten up you work.
STEP 7
Mix up a VERY SMALL amount of GS and using you knife press a little bit on to each side of the mask round it out and you are done!
