Post by syphon on Jun 24, 2013 12:41:00 GMT -5
Since I've shifted my attention away from Gross Waste... I mean Games Workshop... and towards pulp gaming, I decided that a good place to make some pulp scenery was some good old fashioned horror movies. What is pulp without a scary castle, after all?
The Keep in the eponymous movie looks like this:
I'm going to start this project after my master's thesis (or during, who knows?) but there is one issue that I'm intent on tackling now.
As you can see, the wall is all bricks and shiz.
Now, the question is: what material should I use?
I do not have ready access to plasticard, so the product will probably end up having to be foamcore.
I can only get plain foamcore, however. So would scoring it to resemble bricks be viable? Also, I heard that when I do do that, it warps when I undercoat the stuff.
In short... suggestions?
The Keep in the eponymous movie looks like this:
I'm going to start this project after my master's thesis (or during, who knows?) but there is one issue that I'm intent on tackling now.
As you can see, the wall is all bricks and shiz.
Now, the question is: what material should I use?
I do not have ready access to plasticard, so the product will probably end up having to be foamcore.
I can only get plain foamcore, however. So would scoring it to resemble bricks be viable? Also, I heard that when I do do that, it warps when I undercoat the stuff.
In short... suggestions?
