Post by The Guardsmen on Oct 10, 2010 13:58:15 GMT -5
You will need Guardsmen Head Green Stuff exacto knife small file
STEP 1 Select you head but leave part of the frame still attached to the head (so that is easier to handle.) Then mix up a SMALL amount of GS (refer to picture)
STEP 2 Push the GS into the general mask shape (see image.) But make sure you push it "under" where the helmet meets the face.
STEP 3 Push the area of the mask at the nose flat and give the area around the chin a slight upward angle. STEP 4 Press the tip of you exacto knife into the GS to represent vents, using the knife press the area beneath the eyes downward and iv it a slightly rounded shape
STEP 5 Let Dry over night STEP 6 Using the small file (or fine fine sand paper) neaten up you work. STEP 7 Mix up a VERY SMALL amount of GS and using you knife press a little bit on to each side of the mask round it out and you are done!
"We're Drop Troops!, We're meant to be surrounded!"- last words of Sgt. J. Reglent -